![]() ![]() If you don’t have a pan, it’s a good idea to put heavy cardboard down on a dolly and cover it with old towels to prevent a mess. When they replace a toilet, they’ll set the old one in the pan and then roll the whole thing out of the house. To deal with this, plumbers will often place a large utility pan on a flat dolly. Any little tilt or wobble of the toilet as you move it will cause that water to drain out onto the floor. Be thorough: Any water that remains will usually end up on the floor when you remove the toilet.ĭON’T forget to prepare a spot nearby to set the existing toilet once you remove it.ĭespite your water-removing efforts, the toilet’s internal P-trap (located below the bowl) will contain water. Some water will remain in the bottom of the bowl bail it out with a cup or sop it up with a large sponge. DO get rid of as much water as possible before attempting to remove the toilet.Īfter shutting off the water-supply valve to the tank, flush the toilet, holding the handle down to drain as much water as possible from the tank. Armed with a Pick Up Stix and the following advice on best (and worst) practices, you can minimize the mess and hassle and have that new toilet in place in no time. Daniel O’Brian, the technical expert for the online plumbing retailer, has the secret to making this job easier: a simple new tool called the Pick Up Stix. This handy tool is designed to assist professionals as well as savvy do-it-yourselfers in lifting and carrying a toilet. Replacing a toilet is an unpleasant task, not because it’s technically difficult-it’s not-but because toilets are heavy and unwieldy, and no one really wants to get up close and personal. Also, consider raising the flange height with one of our spacer kits.Let’s be honest. Instead, we recommend using a jumbo or extra-thick wax ring. These are used to control the properties and result in a premium, finished product.Ĭan wax rings be stacked on top of one another to compensate for the extra space between the toilet bowl and flange and still create a watertight seal?Īs noted above, although a common practice, Oatey does not recommend stacking two wax seals on top of each other. Oatey and Hercules wax seals are a blend of Slack Wax (unrefined feedstock) and Micro Crystalline Wax (refined feedstock). There are times, though, when the wax ring needs to be replaced, such as when your toilet begins to leak around the base or starts rocking. Once installed, a wax seal should last the life of the toilet, 20 or 30 years, without needing to be changed. If a wax seal is stored in a dry location exposed to temperatures between 70☏ and 110☏, the shelf life is five years from the date of manufacture. ![]() The shelf life depends on how the product is stored. Some wax rings come in a kit that includes new mounting bolts.įor more detailed, step-by-step instructions on replacing a wax toilet ring, check out our project guide to learn more. Anytime a wax seal is replaced, you should replace the T-bolts that attach the toilet to the flange.To ensure a good seal, do not rock the toilet when setting it back in place instead, as mentioned above, twist it from side to side.If you need to warm up your wax ring in a pinch, fill the sink with warm water and let it sit in there for a few minutes to bring it to the right temperature for installation. We recommend keeping the wax itself between 70°-110℉.Here are a few additional installation tips: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |